16
Assembly Instructions
2'' Lag screw
(2)
1-1/4'' lag screws
(12)
2'' lag screws
Slide Installation
1.
Lift and attach 5’ Turbo to units, as shown in
(Fig. 9)
.
Note:
Two people will be required to properly
align the Turbo Tube Slide with your tower.
2.
On either side of the Slide Entrance there is a
dimple. Insert (1) 2'' Screw in either side, so
that the screw goes into the support board
behind, as shown in
(Fig. 9a)
.
3.
Secure Elbow Bracket to 2'’ x 4'' as shown in
(Fig. 9b)
.
Note:
The lower edge of the Elbow Bracket
must sit tightly against the top of the 2'' x 4''
support board.
1-1/4'' Lag screw
bRACKET SHOUlD bE TIGHT
AGAINST 2'' x 4''
Fig. 9
UNDER DECK VIEW
FlUSH
FlUSH
Fig. 9b
Approximate
1-1/4''
Gap
2'' screw
2'' x 4''
(1)
2'' screw
per side
Fig. 9a
(2)
2'' lag screws
(2)
5/16'' Flat
Washers
5/16'' Flat Washer