13
Assembly Instructions
Assembly Instructions
Fig. 6
Slide Barrier Construction
1. Carefully
remove your Barrier Support Boards
from the barrier where you would like to place
your slide, making certain you will have a clear
72'' Safety Zone for your slide.
(Fig. 6)
.
Retain
this lumber and fasteners as you will need
them in a later step.
2. Cut to length
and install (2) 2'' x 4'' Barrier
Support Boards as shown in
(Fig. 6a)
, making
certain the opening between them is 25''.
3. Cut
(1) 2'' x 4'' Barrier Board to the height of
your barrier railing and create a slide opening of
23'', as shown in
(Fig. 6a)
.
4. Reattach
your barrier boards, making certain
they are evenly spaced and do not have a gap
larger than 3'' between each board, as shown in
(Fig. 6a)
.
Fig. 6a
2-1/2'' screw
2''
x 4
''
Cu
t T
o W
idt
h o
f Y
ou
r U
nit
(3)
2-1/2''
screws
per joint
25''
23
''
3-1/4'' Gap
Between Each
Barrier Board
2''
x 4
''
Cu
t T
o W
idt
h o
f Y
ou
r U
nit
NOTE:
This plan uses a generic tower to
illustrate the 5' Turbo Tube Slide being
attached. However, this same procedure
is to be used for any Swing-N-Slide
5’ Tower Playset.
5' DECK HEIGHT
2'' x 4''
Barrier Board
Cut to Height
of Rail
(4)
2-1/2''
screws
per barrier
board