Suzuki Samurai 1986, Руководство по обслуживанию

Страница: 282 / 482

Fig.
High and reverse gear shift fork
Low speed gear shift fork
NOTE:
Gear shift fork
the same.
Fig. 13-65
Note that 3 shift shafts individually have a
locating ball and locating spring, and that 2
interlock balls and an interlock roller are used
between shafts as shown in Fig.
Fig. 13-64
Install low, high and reverse shafts in that order.
1) Install 3 locating springs into 3 holes in
upper case. Fit locating ball in Fig.
13-64) on top of locating spring in hole.
1. Locating spring
2. Locating ball
3. Upper case
2) Insert low speed gear shift shaft into upper
case and low speed shift fork in the direction
as shown in Fig. 1366.
Fig. 13-66
3) As shown below, push down low speed gear
shift shaft locating ball to pass shaft over it
and keep inserting shaft until locating ball
fits in center slot of 3 continuous slots in
shaft.
Drive shift yoke pin into fork and shaft.
13-20