Suzuki Samurai 1986, Руководство по обслуживанию

Страница: 104 / 482

Rocker-Arm Shafts
1) Apply engine oil to rocker arms and rocker
arm shafts.
2) install rocker arms, springs and rocker arm
shafts.
The two rocker arm shafts are not identical.
To distinguish between the two, dimensions
of their stepped ends differ as shown in
Fig. 36-36. Install intake rocker arm shaft,
facing its stepped end to camshaft pulley
side, and exhaust rocker arm shaft, facing
its stepped end to distributor side (rear side).
6
0
0
0
3
3
1. Intake rocker arm shaft
2. 14 mm (0.55 in)
3. Exhaust rocker arm shaft
4. 15 mm (0.59 in)
5. Camshaft pulley side
6. Distributor side
Fig. Rocker arm shafts installation
3) After installing rocker arms, springs, and
rocker arm shafts as shown in Fig. 3-6-37,
tighten rocker arm shaft screws to specified
torque.
Tightening torque
9 12
for rocker arm shaft
0.9 1.2 kg-m
screws
7.0 8.5 lb-ft
NOTE:
Valve clearance is adjusted after all parts are
assembled. So it is not adjusted at this point
Leave rocker arm adjusting screw as loose as
can be.
Intake side
2. Exhaust side
Fig. 3-6-37
Water Inlet Pipe
Install water inlet pipe to cylinder block.
Make sure to fit seal ring @(O-ring) to inlet
pipe before installation.
Fig. 3-6-38
Intake Manifold and Carburetor
1) Install intake manifold gasket to cylinder
head. Use new gasket.
NOTE:
Clean cylinder head mating surface with gasket
before installation.
2) Install intake manifold with carburetor to
cylinder head.
3) Tighten manifold bolts and nuts to specified
torque.
Tightening torque
kg-m
lb-ft
for manifold bolts
and nuts
18 28 1.8 2.8 13.5-20.0
3-46