Superwind 350 12V, Руководство пользователя

Страница: 45 / 79

V 01-2017
www.superwind.com
44
Yaw bearing is stiff,
wind generator does
not follow the wind
direction
Move by hand Repair by authorized service station
11.2 No power output
No power output
Table 11.2
Possible source
of errors
Test Solution
Not enough wind Measure wind speed
Wait for more wind
Annotation: Charging possibly will
start only with 4,5 to 5,5 m/s.
(depending on the battery state of
charge)
Current linkage is
interrupted
Check the cabling Replace defective line or devices
Fuse is blown Check the fuse Replace the fuse
Carbon brushes are
without contact Check the carbon
brushes and the springs
Replace the carbon brushes
Build-in rectifier is
defective
No increased torque
sensible when generator
cables have been short-
circuited.
Repair by authorized service station
11.3 Insufficient power output
Insufficient power output
Table 11.3
Possible source
of errors
Test Solution
Bad electrical
connection
Measure the electric
resistance of the cabling
and devices
Replace defective lines or devices,
clean connectors and terminals
Cable resistance too
high
Check the cable gauges
(cross sections) and
cable lengths
Use cables with higher gauges
(cross sections)
11.4 Battery is not fully charged
Battery is not fully charged
Table 11.4
Possible source
of errors
Test Solution
Battery is too old or
defective
Check fluid level
Fill up with distilled water, replace
defective battery
Fuse is blown Check the fuse(s) Replace the fuse