Superwind 350 12V, Руководство пользователя

Страница: 43 / 79

V 01-2017
www.superwind.com
42
10.1.5 Corrosion protection
The housing, as well as the wind vane, are made of a sea water-proof aluminium
alloy and are additionally protected by a powder coating. This coating however
can only adhere optimally to the housing surface if it is not damaged. Therefore,
check for damage and touch up the coating with suitable lacquer.
All steel parts (e.g. ball bearings, shafts, axles and bolts) are made of stainless
steel and need no special corrosion protection.
10.1.6 Mast
Check your mast or support. Refer to the respective instruction.
10.1.7 Electrical system
Inspections of the electrical system shall only be performed by qualified persons.
Before performing any inspection, make sure that all lines are safe and that the
wind generator will not start unintentionally.
Check all electrical connections, making sure that they are tight and free from
corrosion. Pay particularly attention to battery terminals, since they are especially
prone to corrosion. If corroded, clean and cover them with battery terminal
grease.
Check the battery fluid level and add distilled water when necessary. Refer to the
instructions of the battery manufacturer.
10.2 Maintenance
There is no special maintenance required however the periodic inspections noted
previously must be performed every 12 months.