Supero SUPER 370DDE, Руководство пользователя

Страница: 98 / 171

5-18
S
UPER 370DDE/370SDA User's Manual
Troubleshooting
2. Press “N” for the Create Only option.
3. A window will appear almost immediately confirming that your
Security array has been created. Press any key to reboot the
system
Adding Fault Tolerance to an Existing Drive
FastTrak100 will create a mirrored array using an existing system drive
with data. You must assign the existing drive and another drive of same or
larger capacity to the Mirroring array. The BIOS will send the existing data
to the new blank drive.
WARNING: If you wish to include your current bootable drive using the
Windows NT 4.x or Windows 2000 operating system as part of a
bootable Mirrored (RAID 1) array on your FastTrak100, do NOT con-
nect the hard drive to the FastTrak100 controller yet. You MUST install
the Windows NT4 or 2000 driver software first (see page 5-24) to this
drive while it is still attached to your existing hard drive controller. For
all other Operating Systems, proceed here.
1. After assigning the drives to a Mirroring array, press <Ctrl-Y> keys
to Save your selection. The window below will appear.
2. Press “Y” for the Create and Duplicate option. The window below will
appear asking you to select the Source drive to use. FastBuild will
copy all data from the Source drive to the Target drive.
Array has been created.
<Press Any Key to Reboot>
Do you want the disk image to be duplicated to another? (Yes/No)
Y - Create and Duplicate
N - Create Only
Source Disk
Channel:ID Drive Model Capacity (MB)
Target Disk
Channel:ID Drive Model Capacity (MB)
[Please Select A Source Disk]
Channel:ID Drive Model Capacity (MB)
1 :Master QUANTUMCR8.4A 8063
2 :Master QUANTUMCR8.4A 8063
[
↑
] Up [
↓
] [ESC] Exit [Ctrl-Y] Save
WARNING: Backup any necessary data before proceeding.
Failure to follow this accepted PC practice could result in data
loss.