Supero SUPER 370DDE, Руководство пользователя

Страница: 84 / 171

5-4
S
UPER 370DDE/370SDA User's Manual
Troubleshooting
Figure 1
Figure 1
Installing The Hard Drives
WARNING: If you wish to include your current bootable drive
using the Windows NT 4.x or Windows 2000 operating system as part of
a bootable Mirrored (RAID 1) array on your FastTrak100, do NOT connect
the hard drive to the FastTrak100 controller yet. You MUST install the
Windows NT4 or 2000 driver software first (see page 31) to this drive while
it is still attached to your existing hard drive controller. For all other
Operating Systems, proceed here.
Hard drives must be Ultra ATA/100, Ultra ATA/66, Ultra ATA/33, EIDE and/
or Fast ATA-2 compatible to operate with the FastTrak100 RAID Adapter.
For optimal performance, install all
identical drives of the same model and
capacity. The drives’ matched performance allows the array to function
better as a single drive.
1. Promise recommends using identical drives as part of a
FastTrak100 array. If striping for performance, use up to four new
drives. If mirroring for protection, you can use two new drives OR
use an existing drive and a new drive (the new drive must be the
same size or larger than the existing drive).
2. Configure the jumpers of the hard drive you’re preparing to connect
to the FastTrak100 using the correct “Master” or “Cable-Select”
settings in the positions described in the table below.
NOTE: Sometimes the Master drive with no slave attached is
called “Single.” The master slave setting differentiates two drives
chained on the same connector.