Supero SUPER 370DDE, Руководство пользователя

Страница: 86 / 171

5-6
S
UPER 370DDE/370SDA User's Manual
Troubleshooting
there is a “Hard-Disk Drive Sequence,” place the FastTrak controller as
the second choice in searching for a bootable device. No changes are
needed for CD-ROM drives that are attached to the mainboard IDE
controller.
Processor ID: MHz
Cache: BIOS version: xxx
Server Tag: xxxxx
System Time 18:50:37
System Date Tue May 02, 2000
Diskette Drive A: 3.5 inch, 1.44 MB
Diskette Drive B: Not Installed
Primary Drive 0 Unknown Device
Primary Drive 1 Unknown Device
Secondary Drive 0 CD-ROM Reader
Secondary Drive 1 Unknown Device
Hard-Disk Drive Sequence <ENTER>
Boot Sequence <ENTER>
Checking CMOS Settings
No changes are necessary in the Mainboard CMOS Setup for re-
sources or drive types. Since FastTrak100 is a PCI Plug-n-Play (PnP)
device, the Interrupt and Port address resources are automatically
assigned by the Mainboard’s PCI PnP BIOS.
The FastTrak100 system resources including port address, interrupt,
and BIOS address are
automatically
determined by the system PnP
BIOS. To customize IRQ settings, enter the Mainboard BIOS’s Ad-
vanced PCI setup and follow the manufacturer’s procedures. When the
system is limited by IRQ resources, the FastTrak100 card can be set
for the same IRQ as other PCI cards that support PCI interrupt sharing.
For the FastTrak100 to be the bootable IDE controller, confirm in the
mainboard’s Standard CMOS Setup that the drive types (for
hard disk
drives) are set for “Unknown Device” or “Not Installed” (see below). If