Supero SUPER 370DDE, Руководство пользователя

Страница: 30 / 171

2-2
S
UPER 370DDE/370SDA User's Manual
Installation
Heat Sink
Follow the instructions that came with your processors or heat sinks to
attach heat sinks to the processors. Each of your heat sinks should
have a 3-pin fan cable connecting to the CPU FAN header. Make sure
that good contact is made between the processors and the heat sinks.
Insufficient contact, incorrect types of heat sinks, fans, or thermal
compound used or improper amount of thermal compound applied on the
CPU die can cause the processors to overheat, which may crash the
system.
Processor
You are now ready to install the processors. Your 370DDE motherboard
has two 370-pin, FCPGA type sockets, which support 370-pin Pentium III
FCPGA (not SEPP) 500 MHz-1GHz processors. The 370SDA motherboard
supports only one Pentium III FCPGA 500 MHz-1GHz CPU -- or supports a
single Celeron PPGA/FCPGA 333-700 MHz processor. Lift the lever on the
FCPGA socket and install with the notched corner of the processor oriented
with pin 1. Fully seat the processor into the socket and then close the
lever. See Figure 2-1 for views of the FCPGA 370-pin socket before and
after processor installation -- the PPGA is similar.
2-2 Processor Installation
When handling the processor package, avoid placing
direct pressure on the label area of the fan.
The following pages cover the installation procedures. You should install
the processor in the motherboard first, then install the motherboard in the
chassis, then the memory and add-on cards, and finally the cables and
drivers. Following the installation procedures in the order they appear in
this chapter should eliminate the most common problems encountered when
building a system.
IMPORTANT: Always connect the power cord last, and always re-
move it before adding, removing or changing any hardware compo-
n e n t s .
!