Supermicro SUPERSERVER 6013A-T, Руководство пользователя

Страница: 47 / 126

Chapter 5: Advanced Motherboard Setup
5-9
5-6 Installing Memory
1. Insert the desired number of DIMMs into the memory slots, starting with
Bank 1. The memory scheme is interleaved so you must install two
modules at a time, beginning with Bank 1, then Bank 2.
2. Insert each DIMM module vertically into its slot. Pay attention to the
notch along the bottom of the module to prevent inserting the DIMM
module incorrectly.
3. Gently press down on the DIMM module until it snaps into place in the
slot. Repeat for all modules (see step 1 above).
Memory Support
The X5DPA-TGM+ only supports registered ECC DDR-266/200 MHz SDRAM
memory. If you are using 533 MHz front side bus processor(s), you must
use DDR-266 SDRAM. If you are using 400 MHz FSB (front side bus)
processor(s), you may use either DDR-266 or DDR-200 SDRAM. However, if 400
MHz FSB processor(s) are used, DDR-266 will run at 200 MHz.
!
CAUTION! Exercise extreme care when install-
ing or removing DIMM modules to prevent any
possible damage.
To Install: Insert module vertically and press down until it snaps into place. Pay
attention to the bottom notch.
To Remove: Use your thumbs to gently push each release tab outward to free the DIMM
from the slot.
Figure 5-5. DIMM Installation