Sun Oracle Fire X4470 M2, Руководство по обслуживанию

Страница: 149 / 194

Chapter 8 Troubleshooting the Server and ILOM Defaults 8-15
8.4 Contacting Support
If the troubleshooting procedures in this chapter fail to solve your problem, use
TABLE 8-5
to collect information that you might need to communicate to support
personnel.
net { config | dhcp | ping | flash }
•
config
– Starts a dialog that enables you to change the Oracle ILOM
network settings.
•
dhcp
– Changes the network addressing from static to DHCP.
Note - You must set
ipdiscovery = dhcp
using the
net config
command first.
•
ping
– Sends a ping.
•
flash
– Downloads an Oracle ILOM firmware image. See Section 8.3.4
“Restoring the SP Firmware Image” on page 8-11 for details.
Type
help net
command for more details on these commands.
reset
{
warm | cold
}. Resets the SP and the host.
•
warm
– Resets the SP without affecting a running host.
•
cold
– Resets the SP and the host. It has the effect of powering off the
server.
unconfig { ilom_conf | most | all }
Causes Oracle ILOM to erase any configuration information and returns
the values to defaults the next time Oracle ILOM boots.
•
ilom_conf
– Resets configuration settings but preserves SP network
and baud rate, preferred, and check_physical_presence.
•
most
– Resets the SP data storage, but preserves network and baud
rate, preferred, and check_physical_presence settings.
•
all
– Resets all SP data storage and settings.
Booting Oracle ILOM restores other defaults.
Note -
None of these options erases the dynamic FRU PROMs.
TABLE 8-4
Preboot Menu Commands (Continued)
Command Description