Page 37
5-9
#7040748 - Revision A - September, 2016
MODEL UW-24
MODEL UW-24
Component Removal
Figure 5-17. Evaporator Thermistor
Figure 5-18. Evaporator Fan Assembly
Thermistor
P-Clamp
Evaporator
Fan Motor
Fan Bracket
Motor Mounting
Screws
Bracket Mounting Screws
Fan Blade
Evaporator Thermistors
The evaporator thermistors are attached to the right
side of each evaporator brackets with a “P” clamp and
screw.
To remove an evaporator thermistor, first remove the
wine racks in the appropriate section, then (See Figure
5-17):
1.
Remove the cabinet slides.
2.
Remove the slide spacers and the slide support
spacers.
3.
Remove the evaporator fan cover.
4.
Pull the cabinet thermistor from the clamp.
5.
Pull the evaporator cover forward and feed the cab-
inet thermistor through the grommet, remove the
evaporator cover.
6.
Loosen the screw on the “P” clamp, and remove
the thermistor from the “P” clamp.
7.
Cut thermistor’s wire leads six to twelve inches from
back wall, then pull thermistor from compartment.
Evaporator Fan Assemblies
The evaporator fan assemblies are attached to the rear
wall in each section.
To remove the evaporator fan assembly, first remove
the evaporator cover in the appropriate section, then
(See Figure 5-18):
1.
Extract screws holding assembly to rear wall.
2.
Disconnect fan motor electrical leads and pull
assembly from compartment.