Page 31
5-3
#7040748 - Revision A - September, 2016
MODEL UW-24
MODEL UW-24
Component Removal
EXTERIOR COSMETIC AND MECHANICAL COMPONENTS
Kickplate
To remove the kickplate, extract the mounting screws
located at each end of the kickplate and pull the kick-
plate forward (See Figure 5-1).
Door Switch and Switch Box Bracket Assembly
The door switch is inserted through the hole in the
switch box bracket assembly. Magnet and tabs on the
sides of the switch hold the switch in place. The
assembly is attached to the bottom of the cabinet with
screws.
To remove the switch and switch box bracket assembly,
first remove the kickplate, then (See Figure 5-2):
1.
Extract switch box bracket assembly mounting
screws.
2.
Pull assembly down, then rotate back to front.
3.
Disconnect electrical leads from switch.
4.
Depress tabs on side of switch while pushing switch
out of hole.
Door Gasket
An extruded dart at the back of the door gaskets is
pressed into retaining channels that are part of the door
glass frame.
To remove the door gasket, pull the gasket from the
retaining channels (See Figure 5-3).
Figure 5-1. Kickplate Removal
Kickplate
Mounting Screw
(1 of 2)
Figure 5-2. Light Switch & Switch box
Screws (2)
Bracket
Switch
Figure 5-3. Gasket Removal
Door Gasket
Channel
