Page 30
5-2
#7040748 - Revision A - September, 2016
Component Removal
MODEL UW-24
MODEL UW-24
COMPONENT REMOVAL
This section explains how to remove components from the Model UW-24.
An attempt has been made to arrange these procedures in such a way as to simulate which components would
need to be removed first in order to gain access to other components. When following a component removal proce-
dure, it may be necessary to reference another component removal procedure listed earlier in this section.
NOTE:
Before continuing, please take note of the WARNINGS and CAUTIONS below.
•
IF PULLING A UNIT FROM ITS INSTALLATION BEYOND THE ANTI-TIP COMPONENTS, REMEMBER THAT
IT COULD TIP FORWARD RESULTING IN SERIOUS INJURY OR DEATH. PULLING A UNIT FROM ITS
INSTALLATION SHOULD ONLY BE PERFORMED BY AN AUTHORIZED SERVICE TECHNICIAN OR CERTI-
FIED INSTALLER.
•
TO AVOID ELECTRIC SHOCK, POWER TO THE UNIT MUST BE DISCONNECTED WHENEVER ACCESSING
AND/OR REMOVING COMPONENTS POWERED BY ELECTRICITY OR COMPONENTS NEAR OTHER
ELECTRICAL COMPONENTS. IF THE UNIT IS PLUGGED IN, BUT HAS NOT BEEN SWITCHED ON BY
PRESSING THE POWER KEY, LINE VOLTAGE IS STILL PRESENT AT THE MAIN CONTROL BOARD.
•
IF REMOVING A DOOR OR DRAWER FROM A UNIT, REMEMBER THAT DOORS AND DRAWERS ARE
HEAVY. IF THEY WERE TO FALL, THEY COULD CAUSE SERIOUS PERSONAL INJURY.
•
If working in the compressor area, remember that compressor and tubing may be hot.
•
If working on or around the evaporator or condenser, remember that evaporator and condenser fins are
sharp.