Page 35
5-7
#7040748 - Revision A - September, 2016
MODEL UW-24
MODEL UW-24
Component Removal
Figure 5-12. Control Board Access Panel
Figure 5-13. Control Board
LED Ribbon Cable
Membrane
Switch
Ribbon
Cable
Electrical Connections
Tab
Access Panel
Tab
Tab
Tab
Control Board Access and Removal
The control board is located behind the control panel,
on the bottom of the compartment divider, and is con-
cealed by the service panel. The control board is held
in place by four tabs, one at each corner.
To remove the control board first remove the wine racks
from the lower section, then (See Figure 5-12):
1.
Extract the screws securing the service panel to the
compartment divider.
2.
Let the back of the service panel drop down, and
pull the service panel toward the rear of unit.
To remove the control board (See Figure 5-13):
1.
Disconnect LED ribbon cable
2.
Disconnect membrane switch ribbon cable
3.
Disconnect all other electrical leads from control
board.
4.
Expand tabs at the corners to release control
board, then pull board down and out.
NOTE:
When re-connecting electrical leads to the con-
trol board, be sure the one on the membrane switch rib-
bon cable terminal is next to the one on the control
board.
P3
