Stryker Berchtold CHROMOPHARE, Руководство по обслуживанию и запасным частям

Страница: 80 / 133

75
S
14. Slide the tool “FGEN 1-2” up to make contact with the snap ring. Ensure that the snap ring is oriented as
shown.
WARNING: Wiring can be damaged. Be careful when inserting the fixture into the
joint.
15. Align the tool to allowing guiding of the wiring along the slot as shown.
16. Fully seat the tool into the joint. Ensure that the cardanic is seated flush with the side bearing.
17. With the palm of the hand, deliver a moderate blow to the tool to seat the snap ring onto the side
bearing.
18. Remove the tool from the joint area. It should disengage freely. Visually verify the snap ring is lodged
symmetrically.
WARNING: The snap ring MUST be fully engaged. Failure to ensure it is fully seated
may result in the Light falling.
19. Ensure instructions for proper Variant are being followed.
Note: Skip to Steps 20-21 for Variant 83468(AC Cardanic, Cover Only) and Variant 83289
(NC/NFC Cardanic, Cover Only)
Skip to Steps 22-25 for Variants 83468(AC Cardanic, Cover with 7-Pole)
Skip to Steps 26-32 for Variant 83469(AC Cardanic Control from Light Head Keypad
Skip to Steps 33- for Variant 83471(NC or NFC Cardanic Control from Light Head Keypad)
20. Tuck the cables into the cardanic joint area.