Stratasys Eden250, Руководство пользователя

Страница: 106 / 122

Operating & Maintaining the Eden 3-D Printer
7–30
DOC- 22000 Rev. A
18. Push the head up until you hear it click into place, in both front and
rear holders.
Figure 7-46:Clicking the head into place in the print block
19. Lower the door of the printing head compartment, and tighten the
screws to lock it in place.
20. Tighten the upper and lower screws that secure the printing head in
the printing block (see figure 7 ‐ 39 on page 7 ‐ 27).
Note: Hand-tighten these screws. Do not use a screwdriver.
21. In the Head(s) Replacement screen (see figure 7 ‐ 38 on page 7 ‐ 27), select
the check box to confirm that the head has been replaced, and click
Next
.
22. With your fingers, make sure that the new head is level and even with
the other heads.
Figure 7-47:Checking the level of the new head
23. In the next wizard screen, select the check box to confirm that the new
head is level and even with the other heads, and click
Next
.