Stratasys Eden250, Руководство пользователя

Страница: 86 / 122

Operating & Maintaining the Eden 3-D Printer
7–10
DOC- 22000 Rev. A
5. Click
Next
, and take note of the warning screen.
Figure 7-11:Resin Replacement warning screen
6. To continue, click
Next
.
7. When prompted by the wizard screen, remove the model ‐ material
cartridge. Select the check box to confirm that you have done so, and
click
Next
.
•
If you are performing the short resin ‐ replacement cycle, continue with
step 10.
•
If you are performing the long resin ‐ replacement cycle, continue with
step 8, below.
8. When prompted, insert the cleanser cartridge in place of the model
material that you removed. Select the check box to confirm that you
have done so, and click
Next
.
The wizard flushes the print heads with the cleanser. This takes about
25 minutes.
Figure 7-12:Resin replacement (long cycle): flushing heads with cleanser
9. When prompted, remove the cleanser cartridge. Select the check box
and click
Next
.
Once you start this procedure, you must complete it before you can produce
models with the Eden printer. To perform the procedure at another time,
click
Cancel . If you continue (by clicking Next ) and you do not complete the
procedure, you must start the Resin Replacement wizard again (see step 1
on page 7-8) before producing models.