52
MS 231, MS 231 C, MS 251, MS 251 C
:
Fit the ground wire (1) and short
circuit wire (2) in the
guides (arrows).
Ground wire: Crimped side of
terminal (1) must face outwards.
:
Position the terminal (1) between
the ignition module (2) and
stop (3).
– Check the air gap between the
ignition module and flywheel and
adjust if necessary,
b
7.3
:
Fit the screw (4) with washer and
tighten it down firmly.
:
Press the ground wire (5) fully
into the guide (arrow).
2310RA142 TG
1
2
2310RA143 TG
4
2
3
5
1
Short circuit wire: Crimped side of
terminal (1) must face outwards.
:
Connect terminal of short circuit
wire (2) – make sure the terminal
is pushed fully home.
:
Press the short circuit wire (2)
fully into the guide (arrow).
Check that the ignition lead (1) is
properly seated in the guide.
:
Carefully push the retainers (2)
and (3) into the slots (arrows)
until they snap into place.
– Position filter base in the
carburetor box.
2310RA144 TG
1
2
2310RA145 TG
1
3
2
:
Position the switch lever (1) in the
carburetor box.
:
Position terminal sleeve (2) of
short circuit wire so that its
crimped side faces the cam (3).
:
Push terminal sleeve (2) into the
guide (arrow) as far as stop.
:
Fit the short circuit wire (1) in the
guides (arrows).
– Install the switch lever,
b
10.1
– Fit the contact spring,
b
7.7.4
– Install the filter base,
b
12.3
2310RA146 TG
1
3
2
2310RA147 TG
1
All manuals and user guides at all-guides.com