Stanley STDC001L, Оригинальное руководство пользователя

Страница: 8 / 62

8
ENGLISH
(Original instructions)
The charging indicator (11) will flash green continuously
(slowly).
The charge is complete when the charging indicator (11)
lights green continuously. The charger and the battery can
be left connected indefinitely with the LED illuminated. The
LED will change to flashing green (charging) state as the
charger occasionally tops up the battery change. The
charging indicator (11) will be lit as long as the battery is
connected to the plugged-in charge r .
• Charge discharged batteries within 1 week. Battery life
will be greatly diminished if stored in a discharged state.
Leaving the battery in the charger
The charger and battery pack can be left connected with the
LED glowing indefinitely. The charger will keep the battery
pack fresh and fully charged.
Charger diagnostics
If the charger detects a weak or damaged battery, the
charging indicator (11) will flash red at a fast rate. Proceed
as follows:
• Re-insert the battery (5).
• If the charging indicators continues flashing res at a fast
rate, use a different battery to determine if the charging
process works properly.
• If the replaced battery charges correctly, the original
battery is defective and should be returned to a service
centre for recycling.
• If the new battery gives the same indication as the
original battery, take the charger to be tested at an
authorised service centre.
Note: It may take as long as 60 minutes to determine
that the battery is defective. If the battery is too hot or
too cold, the LED will alternately blink red, fast and
slow, one flash at each speed and repeat
Selecting the direction of rotation (fig. E)
For drilling and for tightening screws, use forward
(clockwise) rotation. For loosening screws or removing a
jammed drill bit, use reverse (counterclockwise) rotation.
• To select forward rotation, push the forward/reverse
slider (2) to the left.
• To select reverse rotation, push the forward/reverse
slider to the right.
• To lock the tool, set the forward/reverse slider into the
centre position.
Selecting the torque
This tool is fitted with a collar to set the torque for various
screwdriving and drilling applications. Large screws and hard
workpiece materials require a higher torque setting than
small screws and soft workpiece materials. For the definition
of the symbol refer to the listing belo w .
• For drilling in wood, metal and plastics, set the torque
adjustment collar (4) to the symbol.
• For screwdriving, set the collar to the desired setting. If
you do not yet know the appropriate setting, proceed as
follows:
- Set the torque adjustment collar (4) to the lowest
torque setting.
- Tighten the first screw.
- If the clutch ratchets before the desired result is
achieved, increase the collar setting and continue
tightening the screw. Repeat until you reach the
correct setting. Use this setting for the remaining
screws.
Speed selector
• For drilling in steel and for screwdriving applications,
slide the speed selector (8) towards the rear of the tool
(1st gear).
• For drilling in materials other than steel, slide the speed
selector (8) towards the front of the tool (2nd gear).
Drilling/screwdriving
• Select forward or reverse rotation using the
forward/reverse slider (2).
• To switch the tool on, press the switch (1). The tool
speed depends on how far you press the switch.
• To switch the tool off, release the switch.
LED work light
The LED work light (7) is activated automatically when the
trigger is depressed. The LED work light will illuminate when
the trigger is partially depressed, before the unit begins
running.