Stanley QB Expert, Инструкция по эксплуатации

Страница: 53 / 214

Programming
Instruction Manual
45
Strategy
(Advanced)
RC / AM Rate Control with Angle Monitor. The controller shuts off the tool
when the rising target rate value is achieved after a selected snug
torque value. The controller also monitors angle. Audit Step torque
and angle readings must fall within their specified limits for the
fastening cycle to be acceptable.
YC / AM
Yield Control with Angle Monitor. The controller shuts off the tool
when the falling target rate value is achieved after a selected snug
torque value. The controller also monitors angle. Audit Step torque
and angle readings must fall within their specified limits for the
fastening cycle to be acceptable.
BACK OFF Reverse Angle Control or Torque Control. The controller runs the tool
in the opposite direction and shuts off the tool when either a lowering
target torque value or a target angle value. Torque has priority over
Angle. Which means the tool will shut off if torque target is reached
before the angle target. Audit Step torque and angle readings must
fall within their specification limits for the fastening cycle to be judged
acceptable.
PC / TM
Position Control with Torque Monitor. The controller shuts off the tool
when the tool zero position is achieved after a selected snug torque
value. The controller also monitors the torque. Audit Step torque and
angle readings must fall within their specified limits for the fastening
cycle to be acceptable.
Torque Target
The torque at which the controller shuts off the tool. Should be greater than Low Torque
and lower than High Torque. Units are the selected torque units.
High Torque
The maximum peak torque for an acceptable fastening cycle (required for all steps). If the
actual torque exceeds this limit the fastening cycle will be flagged as NOK and the RED
LED on the front panel and tool illuminates. Must be greater than Torque Target and less
than or equal to the rated torque marked on the tool. Units are the selected torque units.
Low Torque
The minimum peak torque for an acceptable fastening cycle. If the actual torque does not
reach this limit, the fastening cycle is flagged as NOK and the YELLOW LED on the front
panel and tool illuminates. Must be less than the Torque Target. Units are the selected
torque units.
Torque Display
Selects which achieved torque value to store, display and use to compare against limits
for fastening cycle status. PEAK will choose the peak torque during the step, FINAL will
choose the torque at peak angle during the step.
Accumulate
Angle
Yes carries the angle over from the previous step. The angle value is from the previous
step’s Snug Torque to this active step’s peak angle. No turns this function off. The default
is NO requiring a Snug Torque value for this step.
Snug Torque
The point in the step when the controller begins to monitor the tool’s output angle. Should
be greater than 0 and less than Low Torque. A value of 50% of Torque Target is a good
starting point. Units are the selected torque units.
AC TM
AC TC
TC AM
AC/TA
AC TM
AC TC
TC AM
AC/TA
AC TM
AC TC
TC AM
AC/TA
AC TM
AC TC
TC AM
AC/TA