Stanley QB Expert, Инструкция по эксплуатации

Страница: 50 / 214

SETUP Area
QB Expert Alpha Controller
42
Limit Rejects
Limits the number of NOK (Not OK) fastening cycles in a Task. If the limit is achieved the
tool is disabled. Use Reset Job, Task Select or Task Select Bit inputs to recover. Yes turns
this function on and increases the Task menu to insert the Reject Count parameter. No
turns this function off. The default value is No.
Reject Count The maximum number of NOK fastening cycles allowed during this
Task. The default value is 3.
Units
Operating torque units. See section “3.1.1.1 Wizard Screens” on page 31 for a list of
available units. Each Task does not have to use the same operating torque units as the
other Tasks. The default value is Nm.
Thread Direction
For tightening a right-hand fastener use clockwise (CW). Use counter-clockwise (CCW) for
left-hand fasteners. The default value is clockwise (CW).
Threshold
Torque
The torque level during the fastening cycle when the In Cycle output transitions high. Data
is not stored, or available to Alpha Toolbox, unless Threshold Torque is exceeded during
the fastening cycle. A good starting point is 20% of Target Torque. The default value is 0.
Statistical Torque
The torque level required to be exceeded before the fastening cycle data is included into
Statistics or sent via a network protocol. The default value is 0.
Disassembly
Speed
The speed of the tool during (Reverse) operation in RPM (revolutions per minute). The
default value is 9999. To limit the speed of the tool reduce this parameter to a value less
than the maximum speed of the tool.
Disassembly
Acceleration The rate at which the tool gets to Disassembly Speed in RPM/s (revolutions per minute per
second). The default value is 3,000.
Cycle Lock-Out
This is a timer, in seconds, that activates after the tool has reached its target. While active,
the tool is disabled.
Torque Rate
This section sets values used in determining fastening cycle torque rate used in the Rate
Control or Yield Control strategies.
Torque Average
Number of Torque samples averaged for the Rate calculation.
Calculates a running average from torque samples taken every
millisecond. A higher number gives a smoother Rate. The default
value is 10 m sec.
Angle Interval
Used to calculate the Torque vs. Angle Rate. Larger intervals may give
a smoother Rate. The default value is 20°.
Modified
A value that is changed by the controller to indicate the date and time parameter values
were last changed in this Task or associated Steps.
3.1.2.3 Manage Button (Task)
Manage enables Tasks and their settings to be added, deleted, copied to the clipboard and pasted into another