Stanley QB Expert, Инструкция по эксплуатации

Страница: 47 / 214

Programming
Instruction Manual
39
Enable Error
Proofing
The value of Yes causes the tool to disable after the accumulated fastener count equals
the target fastener count for the job, unless Auto Reset Job is set to Yes. A Trigger or
Input is required to Reset the Job and set the accumulated count to zero. Yes also enables
more parameters that will dynamically appear on the screen, see below. The value of No
keeps the tool enabled even after the Job’s target count is met. The count will not increase
beyond the target value. The value of No will not cause new parameters to appear.
Disable
Disassembly
This section identifies whether the tool removes the Disassembly
(Reverse) function on one of the following events:
On Cycle OK
Yes does not allow the use of Disassembly mode
after each OK fastening cycle. The tool can be used
to back out fasteners after a NOK fastening cycle.
No allows the use of Disassembly mode after any
fastening cycle unless the logic of the following two
events is met.
On Job
Complete
Yes does not allow the use of Disassembly mode
after the active Job is complete (accumulated
count equals target count). No allows the use of
Disassembly mode after a Job is complete unless the
logic of the other two events is met.
On All
Fasteners
Removed
Yes does not allow the use of Disassembly
mode after all fasteners have been removed i.e.
accumulated count is back to zero. No allows the use
of Disassembly mode after all fasteners have been
removed unless the logic of the above two events is
met.
Disable
Assembly
This identifies whether the tool disables after each Task has
completed. This requires a Reset Job, Task Select or Task Select Bit
input to select an incomplete Task which enables the tool for an
incomplete Task only. If Auto Sequence Task is used, the tool re-
enables when the active Task switches to an incomplete Task.
On Task
Complete
Yes disables the tool when the active Task is
complete. If an input switches the controller to a
completed Task, the tool is disabled. If an input
switches the controller to an incomplete Task, the
tool is enabled to complete the Task. No will not
disable the tool when the active Task is complete.
Enable Job
Timer
A value of YES invokes the Job Timer. The Job Timer starts when the first bolt of the batch
count exceeds Threshold Torque (In Cycle) and stops when the programmed number of
seconds has elapsed. If the timer times out before the batch count is complete the Job is
set to complete, the tool is disabled and the Job Complete output is energized.
A value of No disables the Job Timer.
Job Timer Value is in seconds. Maximum is 9999.9 seconds, minimum is 1 seconds.