Standard Horizon CP190i, Руководство пользователя

Страница: 78 / 160

CP190i and CPF190i Page 79
· Route legs for which there was not sufficient data to be checked are displayed in
YELLOW. It means that no problems were found but the data was not sufficient or not
available at all to classify such a leg as safe.
Figure 9.8.0 - Example of dangerous objects found on the chart
To activate this function:
AUTOMATIC CHECK Turns the Route Check feature On or Off. Turn the Automatic Route Check on after you
have created a new Route, or if you inserted a new Waypoint, deleted, moved or edited
any Waypoint in a saved Route to confirm the Route can be safely navigated.
ROUTE WIDTH This selection allows you to select the width from the left and right of the Route leg where
the GPS Chart Plotter will check to confirm navigation threats. See the picture below. The
default for this selection is 0.04NM.
DEPTH LIMIT This selection allows you to select the water depth in the Route width area so the GPS
Chart Plotter can check and confirm underwater threats. It checks if some objects with
the depth attribute (like Shallow Water, Dredged Areas, Diffusers, Obstructions, Pingos,
Production Installation and Wrecks) are above this depth level. Only if the depth attribute
is above the depth limit are they found and considered as dangerous. See the picture
below. The default setting is 10FT.
ACCURACY Defines a segment length into which a leg of the Route is divided in order to execute the
search for dangerous objects with better accuracy. When accuracy is maximal, a
segment length is the shortest. When accuracy is minimal, a segment length is the
longest. Selects among Minimum, Low, Medium, High and Maximum. See the picture
below. The default setting is Medium.
ROUTE CHECK REPORT Shows the list of the dangerous objects found on the charts crossed by the Route.
A
B
C
D
E
F
A - B = Width
C - D = Depth
E -F = Accuracy
Figure 9.8.0a - Route Check parameters