© 2014 SPX CORPORATION
19
Form No. 1000773
Rev. 0 August 12, 2014
1. SET UP
Begin by visually checking the MCS unit, cables, sensors, cylinders and connectors
(electrical with cables and hydraulic hoses) to confirm the integrity of all components
and that there is no visible signs of damage.
2. COMPONENTS
Make sure that all components such as hoses, couplers, and cylin
-
ders are rated for for the maximum operating pressure provided by
the pump unit (700 bar).
3. DOCUMENTATION
IMPORTANT:
To avoid operator error and to document the performance of each opera
-
tional step it is recommended that the operator fills in a checklist as shown in Annex 1 of
this
instruction sheet during the Motion Control System operation.
4. INSTALLATION
Mechanicals set up
• Fill Reservoir with 40 Gallons (150L) of Power team hydraulic oil (Part Nos. 9616, 9636,
9637, 9638)
• Once the MCS has been moved into place, with no power cord attached, begin to
physically connect the cylinders to of the MCS with the appropriate hoses. Position the
magnetic bases of the position sensors by the appropriate cylinders and attach the ap
-
propriate cable to each position sensor and its respective connector on the MCS face
plate.
OPERATING INSTRUCTIONS
WARNING
