© 2014 SPX CORPORATION
32
Form No. 1000773
Rev. 0 August 12, 2014
• Once all of the alarms have been re-set
you can proceed to setting up the
cylinder parameters. This will be
accomplished by pressing the
SETTINGS
button in the middle bottom
of the touch screen.
•
NOTE
: this step can also be
performed before all of the alarms
are re-set. On the first
SETTINGS
page , you enter the solenoid “ON”
time, solenoid “OFF” time and the
Release Quick Discharge pressure
(the Quick Discharge can be
activated at all system pressures
below this point)
• By pressing the box for the ON time
value, a keypad will come up on the
screen which will allow you to enter
the ON time. In the example above
it shows 110 msec. Press enter and
the value is placed in the program.
SET UP AND START UP CONTINUED
