© 2014 SPX CORPORATION
35
Form No. 1000773
Rev. 0 August 12, 2014
• After each entry, be sure to press the
ENTER
key so the data is stored in the program. You
can modify this data at any time. However, once the data is entered and the lift has com
-
menced, you should not attempt to change the data in the program.
• For the initial setup, it will be
necessary to enter all of the data for
each of the cylinders you will be
using for the lift. You can advance page
by page by touching the screen in the
bottom right hand corner where it says
NEXT PAGE
• If you go to the next cylinder and it is off,
just press the
OFF
button in the upper
left hand portion of the screen to turn
the cylinder
ON
. On the
HOME
page,
you can readily see which cylinders
(LIFT POINTS) are
ON
and which
cylinders (LIFT POINTS) have been
turned
OFF
.
• Here you can see that Cylinders
1, 2, 3 and 4 are
ON
, while
Cylinders 5, 6, 7, and 8 are
OFF
.
SET UP AND START UP CONTINUED
