Spirax Sarco CSM-C, Инструкция по установке и обслуживанию

Страница: 51 / 56

3.696.5275.210
47
Control Cabinet - Inspection
(Fig. 31)
The contol cabinet system allows the full control of the Compact Steam Generators.
The system requires power to operate, therefore in the case of a power failure, the system
will totally shutdown the unit. If it is mandatory that the unit remain in operation during
power failures, it should be wired into the emergency power system.
Before this is done, it is the duty of the installer / operator to check local codes and
requirements to assure that this is an acceptable configuration.
The system should be checked twice yearly (see documentation for the system provided
with the unit for specific inspection intervals and test routine). If the system is found to
be malfunctioning and it is not possible to identify the fault, the unit must be replaced. To
replace the unit please follow the procedure outlined below:
∆
Note: The exact location and configuration of the solenoid safety system can
vary between units. See the drawing and design specifications supplied with the
unit for the exact placement and configuration.
∆
The combination of electricity, steam, and water can pose a very dangerous
situation. Turn off / disconnect all electric power before attempting any maintenance
procedure.
1. Follow the shutdown procedure (page 22) to take the unit off-line before attempting to
change any part of the system.
2. Refer to Spirax Sarco technical department for repair or substitution.
3. Follow the start-up procedures (page 21) to put the unit back on-line. Carefully check
all connections for any sign of leakage.
Fig. 31
PLC Touchscreen
Power
Emergency stop
Block reset
Alarm
Mains switch
Door lock
Door lock