Spirax Sarco CSM-C, Инструкция по установке и обслуживанию

Страница: 15 / 56

3.696.5275.210
11
Components
All other components included in CSM-C Steam Generators have been specifically selected
to meet the individual design specifications of each unit and HTM 2031.
Spirax Sarco has all components to control the steam generators and they are judged to
be of the highest quality.
Warranty Information
All components used in Spirax Sarco Steam Generators are warranted for one (1) year
from commissioning or eighteen (18) months from date of delivery, whichever comes first.
In some cases, extended warranties are available on an individual basis, at extra cost.
General Notes and Warnings
• This manual is intended to cover installation, operation, and maintenance procedures
for Spirax Sarco CSM-C Compact Steam Generators. If specific installation, operation,
and / or maintenance procedures are not clearly understood, contact Spirax Sarco for
clarification before proceeding.
• All installation, operation, and maintenance procedures should be performed only by
experienced, trained, and certified personnel. Personnel should be trained in correct piping
and electrical procedures and methods, and should be experienced in working with steam
and thermal oil/superheated water systems. Spirax Sarco CSM-C Steam Generators are
designed for indoor use only, unless otherwise required by design specifications. Each
unit requires at least one metre clearance at the front and rear, and 500 mm above the
unit. It should be located on a level surface (no more than one-half degree [½°] of slope),
capable of supporting the total weight of the unit when filled to capacity. The unit should
be mounted to the floor following applicable architectural and local code requirements
for the specific installation site. In areas prone to seismic activity, it is recommended that
the unit be mounted to the floor according to recommended procedures and codes for
the site / location, to make the units less susceptible to seismic damage.
• Fault finding and maintenance procedures are detailed starting on page 26.
• CSM-C Steam Generators are available in a various range of operating pressures and
flow rates. For the specific ranges for your unit, refer to the design specifications and
accompanying literature and drawings supplied with the unit.
• Should the unit be damaged during installation, operation, or maintenance, complete the
following steps.
1. Turn off the power to the unit.
2. Turn off the primary supply inlet (steam) valve.
3. Turn off the condensate water return valves.
4. Turn off the clean steam outlet valve (if present).
5. Turn off feed water inlet valves.
6. Contact in-house maintenance personnel.
All pipework connections for clean steam and water should be flanged or sanitary design,
type of gasket material should be suitable for clean steam applications.
∆
Warnings:
As with any piece of equipment that utilizes steam under pressure, as well as
electricity, the potential exists for severe personal injury if proper installation,
operation, and maintenance procedures are not followed.