SK375-AT3
Drive line
Truck
SPIERINGS MOBILE CRANES USER MANUAL V 0.0
11-7
Nov
2
0
1
4
C
h
a
n
g
e
s
a
n
d
t
y
p
o
g
ra
p
h
ic
a
l
e
rr
o
rs
r
e
s
e
rv
e
d
.
©
2
0
1
4
S
p
ie
ri
n
g
s
M
o
b
ile
Cr
a
n
e
s
–
A
ll r
ig
h
ts
r
e
s
e
rv
e
d
.
11.3.2.
Checking oil level transfer case
Shaft 1 (
) is the input shaft and shaft 2 (
) is the output shaft for driving axle 1.
At the rear the output shaft for the driving of driving axle 3 is located.
1. Make sure that the vehicle stands on a flat horizontal surface;
2. Remove
filler
plug 1
from the opening;
3. Remove
level plug 3
;
4. The oil level must just be under the
level plug 3
:
-
If this is not the case, top up oil (
§ 11.3.3. Refreshing oil transfer
filler necks
till the oil leaves
level plug 3
;
5. Let the oil drain;
6. Mount the
plugs
1
and
3
.
CAUTION!
In order to avoid measurement errors, the oil level may not be checked immediately
after operating. Measuring with a cold motor is also not correct. It is better to drive
the vehicle for a moment (if the engine is cold) before measuring the oil level.
In this way the oil is spread around the entire transfer case.
The oil temperature must be below 40 °C.
CHECK / TEST!
Check the oil level of the transfer case every 2 months at normal operating
conditions. The oil temperature must be below 40 °C.
As 1
As 2
Picture 11-7
