Spectra Watermakers LB-20000, Инструкция по установке и эксплуатации

Страница: 52 / 65

52
“Salinity High”

High product water salinity

Chlorine damage to mem-
branes

Defective salinity probe or
cable, cable disconnected

Check for low feed pressure

Check for leaks at high pressure
hoses

Remove and clean probe contacts.
Check calibration

Check cable connections

Clean membrane
SYMPTOMS PROBABLE CAUSE REMEDY
“System Stalled”
alarm is caused ty the roto-
flow not reading properly, if
no product flow the system
alarms “System Stalled”

Pressure relief valve open

Intake thru-hull closed

Airlocked system

No signal from Rotoflow
meter

Close pressure relief valve

Check thru-hull

Purge air

Check wiring, confirm roto-
flow is spinning, clean or re-
place Rotoflow meter

Check brine discharge

Clean membrane
“High Pressure”

Blocked brine discharge or
product line

Fouled membrane
“Re-starting”

No signal from Rotoflow meter
at startup.

System airlocked

See remedy above for “system
stalled”
“Service Prefilter”

Clogged filters

Loose or defective pres-
sure sensor wires

Install new filters

Check sensor wiring

If the error persists, follow
Prefilter Calibration instruc-
tions.
Troubleshooting Spectra Connect Alarms
“Can’t Connect to Water-
maker from Web Browser”

Device (phone/tablet/
computer) not connected to
same network

Router/Switch turned off

Watermaker turned off

Connecting to wrong web
address

Check the wireless network on your
mobile device or computer

If using a wired connection, confirm
you are connected to the same net-
work.

Make sure Router/switch has power.

Restart Router/Switch

Make sure watermaker is powered on

Confirm Device IP address matches
address typed into browser