Z-axis Automatic SpotLok
Automatic SpotLok (like PlaneLok) can be used to align and hold the plumb beam automatically to the
SF601’s center point continuously adjusting the Z- and X- axis until exiting this mode.
The UL looks always to the center position of the SF601 and re-adjust the beam
immediately to the center to avoid any setup/alignment drift caused by vibrations or
temperature influences (e.g. when working on concrete pads, facade applications).
Using SpotLok, the plumb beam can be aligned automatically to one direction hub
(up to 80 m (260 ft) located in front of the plumb beam.
1. Set up the laser over the start point.
2. Place the
SF601 Spot Finder
at the second reference point.
3. Press and release the MENU button at the Standard Display and select
SpotLok
.
4. Pressing and releasing
button 4
starts the automatic spot alignment while the plumb
beam becomes a rotating fan beam.
Note:
Spot Lok can also be started via infrared using the RC603N.
Note:
The display falls back to the standard display while a
Spot Finder and lock icon
is flashing.
The plumb beam will be automatically aligned to the center of the SF601.
5. After SpotLok is complete all 4 red LEDs at the SF601 are on and the icons stop flashing.
The
transmitter‘s plumb beam is always checking for perfect alignment to the center of the SF601.
After 5 minutes, all 4 LEDs flash every 5 seconds to confirm the correct alignment.
Note:
Automatic SpotLok can be exited any time by pressing and releasing
button 3
(ESC).
Special Features - Vertical Setup
