Spectra Logic Spectra nTier300, Руководство по установке

Страница: 24 / 88

Chapter 2 – Installing the nTier300 VTL
24
Prepare the Rails
Disassemble the rail assemblies. Each assembly consists of an outer rail and an inner
slider.
1. Extend the slider from the outer rail until the safety latch is visible, as shown in
Figure 2-8.
2.
Press up on the latch as shown in Figure 2-8 to release the latch.
3.
Pull the slider completely out of the outer rail.
4.
Repeat steps 1–3 for the second rail assembly.
Install the Sliders on the Chassis
1.
Remove the nTier300 VTL chassis from its bag and place it on a sturdy work surface
where you can reach both sides of the chassis. Having two people for this task
simplifies lifting and moving the chassis.
2.
Position a slider against one side of the chassis with the latch toward the rear of the
chassis, as shown in Figure 2-9. Make sure the safety latch is visible.
Figure 2-8 The safety latch and mounting holes.
o
Figure 2-9 Position the latch toward the rear.
Press up to release safety latch Slider Outer rail
Latch
Rear of chassis