Operating instructions UVR-300/UVR-400 | Heinz Soyer Bolzenschweißtechnik
53
8 Preparing the devices for the welding operation
The following describes the tasks required for the welding process. The basic
requirements for the welding process are described in these instructions:
The proper connection of the devices
The appropriate set-up of the stud welding gun or welding head for the stud
diameter to be processed
The appropriate setting of the universal feeder for the stud diameter
This requires mechanical adjustment/conversions to the respective stud diameter and
programme settings for the respective welding situation.
Conversion sets
To convert the universal feeder, you require a conversion set with the required parts.
Hazards due to incorrect working method
Hazards for operators and third parties can arise due to an incorrect working method.
Ensure sufficient stability and a dry installation location for the device.
Make sure you do not knock over the device or pull it down from its stand
with the gun cables.
Ensure your own good stability while welding, especially during mobile use.
Do not hold the workpiece in your hands while welding. The workpiece must
be securely fixed during the welding process.
Never wrap the gun lines around parts of your body (e.g. arm) as electric
fields can occur.
If the gun is not positioned properly or the gun settings are incorrect, a flash
of light can occur during welding. Do not look directly into the flash.
The gun carries out lifting movements during the welding process. Do not
hold the gun tight in the area of moving parts.