South bend SB1097, Руководство пользователя, Страница: 45 / 60

South Bend Tools
For Machines Mfd. Since 02/21 Model SB1097
-43-
S E R V I C E
Calibrating
Miter Gauge
To calibrate miter gauge:
1. DISCONNECT MACHINE FROM POWER!
2. Remove sanding belt.
3. Mount miter gauge in main table T-slot and
adjust platen tilt to 0 °.
4. Set one edge of 90 ° square against face of
platen as shown in Figure 83.
5. Adjust miter angle until perpendicular to
face of platen (see Figure 83).
This procedure ensures the miter gauge angle is
accurate.
Tools Needed Qty
90 ° Square .............................................................1
Phillips Head Screwdriver #2 ...............................1
Figure Figure 83. Square positioned to check miter angle. . Square positioned to check miter angle.
Platen Platen
Miter Gauge Miter Gauge
90 90 °° Square Square
!
—
If miter scale reads 0
°
when miter stop is
perpendicular to platen, no calibration is
required.
—
If miter scale does not read 0
°
when miter
stop is perpendicular to platen, proceed to
Step 5.
6. Loosen pointer Phillips head screw (see
Figure 84), adjust pointer to 0
° , then
tighten screw.
Pointer Pointer
Figure Figure 84. Miter scale pointer components. . Miter scale pointer components.
7. Check accuracy with 90
°
square before
installing sanding belt.
Pointer Pointer
Screw Screw
!