South bend SB1097, Руководство пользователя, Страница: 42 / 60

-40-
For Machines Mfd. Since 02/21
South Bend Tools
Model SB1097
M A I N T E N A N C E
Gearbox
Lubrication Type ... T28042 or ISO-VG 320 Equiv.
Amount .................................................. As Needed
Frequency ........................ Every 500 Hours of Use
Items Needed Qty
Hex Wrenches 4, 5mm ................................... 1 Ea.
Wrench or Socket 10mm .......................................1
Thread-Locking Tape ............................As Needed
To check/refill gearbox oil:
1. DISCONNECT MACHINE FROM POWER!
2. Tilt platen to horizontal position (refer to
Adjusting Platen Tilt on Page 30).
3.
Remove (2) cap screws and flat washers
shown in Figure 76.
4. Remove (2) flange bolts shown in Figure 76
to remove gearbox cover.
Figure Figure 76. Location of gearbox cap screws and flange . Location of gearbox cap screws and flange
bolts. bolts.
x 2
x 2
8. Check spindle connector set screws shown in
Figure 79 and tighten if loose.
Figure Figure 79. Location of spindle connector set screws. . Location of spindle connector set screws.
9. Install gearbox cover and fasteners removed
in Steps 3
–
4.
5. Remove oil fill plug on top of gearbox (see
Figure 77) and dip clean hex wrench about
1" into hole.
— If hex wrench reaches oil, no additional
gear oil is needed.
—
If hex wrench does not reach oil, add gear
oil until dipping hex wrench reaches oil
level.
Figure Figure 78. Location of eccentric gear set screws. . Location of eccentric gear set screws.
Figure Figure 77. Gearbox oil fill plug location. . Gearbox oil fill plug location.
Oil Fill Plug Oil Fill Plug
6.
Clean any existing tape off of oil fill plug
threads and wrap with new thread-locking
tape before re-installing.
7.
Check set screws on eccentric gear and
tighten if loose (see Figure 78).