South bend SB1097, Руководство пользователя, Страница: 44 / 60

SERVICE
-42-
For Machines Mfd. Since 02/21
South Bend Tools
Model SB1097
S E R V I C E
Calibrating Platen Tilt
To calibrate platen tilt:
1. DISCONNECT MACHINE FROM POWER!
2. Remove sanding belt.
3. Set one edge of 90 ° square on main table
surface, as shown in Figure 81.
4. Adjust platen angle until perpendicular to
face of platen (see Figure 81).
For best sanding results, ensure the platen angle
is calibrated correctly. If calibrated correctly, the
scale should read 90 ° when perpendicular to the
sanding belt.
Tools Needed Qty
90
°
Square .............................................................1
Phillips Head Screwdriver #2 ...............................1
Figure Figure 81. Square positioned to check platen angle. . Square positioned to check platen angle.
Platen Platen
Main Table Main Table
90 90 °° Square Square
!
—
If tilt scale reads 90
°
when platen is
perpendicular to table, no calibration is
required.
—
If tilt scale does not read 90
°
when
platen is perpendicular to table, proceed
to Step 5.
5. Loosen Phillips head screw (see Figure 82),
adjust pointer to 90 ° , then tighten screw.
Pointer Pointer
Figure Figure 82. Tilt scale pointer components. . Tilt scale pointer components.
6.
Check accuracy with 90
°
square before
installing sanding belt.