South bend SB1097, Руководство пользователя, Страница: 33 / 60

South Bend Tools
For Machines Mfd. Since 02/21 Model SB1097
-31-
O P E R A T I O N
Installing Fence
The Model SB1097 comes with a removable fence
to assist sanding operations when the platen is
in the horizontal position.
To install fence:
1. DISCONNECT MACHINE FROM POWER!
2. Set fence on main table and align slots with
threaded holes in table (see Figure 51).
3. Secure fence to table with (2)
5
⁄
16
"-18 x 1"
knob bolts and
5
/
16
" fender washers (see
Figure 51).
Figure Figure 51. Fence installed on main table. . Fence installed on main table.
Fence Fence
x 2
Main Table Main Table
Bevel Sanding
Adjust the platen tilt to match the angle you
wish to sand on a workpiece. For additional
control over the workpiece, use the miter gauge
or backstop to support workpieces during bevel-
sanding operations. Always keep the workpiece
against the table and use two hands to control it.
Figure Figure 50. Typical bevel sanding operation. . Typical bevel sanding operation.
To bevel sand:
1. Set platen tilt to match angle of bevel
on workpiece, and set main table height
to match workpiece thickness (refer to
Adjusting Platen Tilt on Page 30 and
Adjusting Main Table on Page 29).
2. Connect machine to power, turn it ON, and
allow it to reach full speed.
3. Support workpiece against miter gauge or
backstop and slowly feed workpiece into
moving belt with light, even pressure.
Maintain control of workpiece, as shown in
Figure 50. DO NOT force workpiece against
belt.
Items Needed Qty
Knob Bolts
5
⁄
16
"-18 x 1" ..........................................2
Fender Washers
5
⁄
16
" ..............................................2