South bend SB1097, Руководство пользователя, Страница: 36 / 60

-34-
For Machines Mfd. Since 02/21
South Bend Tools
Model SB1097
O P E R A T I O N
3. Tighten end table height lock handle to
secure.
4. Install smallest table insert that fits around
sanding drum or roller to keep clearance gap
equal to or less than
1
⁄
16
" (see Figure 60 and
Installing Sanding Drum on Page 32 for
more information).
End Table End Table
End Table End Table
Height Height
Lock Handle Lock Handle
Adjusting End Table
The end table has 10" of travel that can
accommodate various sanding operations and
decrease spot wear on the sanding drums.
To adjust end table:
1. Loosen end table height lock handle (see
Figure 59).
2. Tilt end table to desired height (see
Figure 59).
Figure Figure 59. End table height components. . End table height components.
Contour Sanding
Contour sanding operations produce a high-
quality sanding finish on inside contours and are
performed on the end table with the workpiece
pressing against one of the sanding drums or
against the roller. Always use two hands to
maintain the best control.
To contour sand:
1. DISCONNECT MACHINE FROM POWER!
2. Open auxiliary dust hood to access sanding
roller (or refer to Installing Sanding Drum
on Page 32 to install sanding drum).
3. Adjust end table height as desired (see
Adjusting End Table).
4. Connect machine to power, turn it ON, and
allow it to reach full speed.
5. While securely holding workpiece, slowly
press workpiece against drum or roller with
light, even pressure. Maintain control of
workpiece, as shown in Figure 61, while
maintaining consistent pressure against end
table. Use extra caution when sanding end
grain.
Figure Figure 61. Typical contour sanding operation. . Typical contour sanding operation.
Do not contour sand without end table
properly installed or serious personal injury
could result.
Figure Figure 60. Table insert with less than . Table insert with less than
1 1
⁄
16 16
" clearance. " clearance.
1 1
⁄⁄
16 16
" Clearance " Clearance
Table Insert Table Insert