SoundExpression SE14SRS, Руководство пользователя

Страница: 47 / 72

47
Command Description
Speaker control
ATM0 Disables the modem speaker.
ATM1 Turns speaker on until
carrier has been detected.
(default)
ATM2 Speaker is always on.
ATM3 Speaker is off when receiving
carrier and during dialing,
but off during answering.
Automode enable
ATN0 Requires speed of the
connection be that specified
by the value of S37.
ATN1 Permits handshaking at any
speed supported by both
modems. (default)
Return to on line state mode
ATO0 Switches the modem from
command mode to on-
line mode without dialing.
ATO1 Switches from command
mode to on-line mode and
initiates an equalizer retrain
sequence.
Mode responses
ATQ0 Enables result codes to be
issued to the screen.
(default)
ATQ1 Disables result codes to be
issued to the screen.
Command Description
Result code format
ATV0 Numeric format.
ATV1 Verbal format. (default)
Error correction message control
ATW0 Error correction call progress
not reported. (default)
ATW1 Call progress reported.
ATW2 Call progress not reported.
Connect xxxx message
reports DCE speed (e.g.,
CONNECT 28800).
Extended result codes
ATX0 Disables monitoring of busy
tones unless forced otherwise
by country requirements;
sends only OK, CONNECT,
RING, NO CARRIER,
ERROR and NO ANSWER
result codes.
ATX1 Disables monitoring of busy
tones unless forced otherwise
by country requirements;
sends only OK, CONNECT,
RING, NO CARRIER,
ERROR, NO ANSWER and
CONNECT XXXX result
codes.
ATX2 Disables monitoring of busy
tones unless forced otherwise
by country requirements;
sends only OK, CONNECT,
RING, NO CARRIER,
Modem Command Reference