SoundExpression SE14SRS, Руководство пользователя

Страница: 41 / 72

41
Appendix H: Compliance
Information
FCC Statement:
This device complies with part 15 of the FCC
rules. Operation is subject to the following
two conditions:
(1) This device may not cause harmful
interference.
(2) This device must accept any interference
received including interference that may
cause undesired operation.
THIS UNIT COMPLIES WITH FCC PART
68 AS OF DATE OF MANUFACTURE.
This equipment has been tested and found to
comply with the limits for a Class B digital
device, pursuant to Part 15 of FCC rules.
These limits are designed to provide
reasonable protection against harmful
interference in a residential installation. This
equipment generates, uses, and can radiate
radio frequency energy and, if not installed in
accordance with the instructions, may cause
harmful interference to radio
communications. However, there is no
guarantee that interference will not occur in a
particular installation. If this equipment does
cause harmful interference to radio or
television reception, which can be determined
by turning the equipment off and on, the user
is encouraged to try to correct the interference
by one or more of the following measures:
• Re-orient or relocate the receiving antennae.
• Increase the separation between the
equipment and the receiver.
• Connect the equipment into an outlet on a
circuit different from that to which the
receiver is connected.
• Consult the dealer or an experienced radio/
TV technician for help.
Note: This unit was tested with shielded
cables on the peripheral devices. Shielded
cables must be used with the unit to insure
compliance.
Note: The manufacturer is not responsible for
any radio or TV interference caused by
unauthorized modifications to this
equipment. Such modifications could void
the user ’s authority to operate the equipment.
Notification to the Telephone
Company
Notification to the telephone company is no
longer required prior to connecting the registered
equipment but upon request from the telephone
company the user shall tell the telephone
company which line the equipment is connected
to as well as the registration number and the
ringer equivalence of the registered protective
circuitry. In most, but not all areas, the sum of all
RENs should be 5.0 or less. The FCC Registration
number and Ringer Equivalence number are
printed on the main chip in the center of the
internal modem board.
Malfunction of the Equipment
In the event that the modem should fail to
operate properly, the customer shall disconnect
the equipment from the telephone line to
determine if it is the customer’s equipment
which is not working properly, or if the problem
is with the modem, the user shall discontinue use
until it is repaired. In the event service is needed
the user should contact the vendor from whom
you purchased the modem.
Telephone Connection
Requirements
Except for telephone company-provided ringers,
all connections to the telephone network shall be
made through standard plugs and standard
telephone company-provided jacks, or
equivalent, in such a manner as to allow for easy
and immediate disconnection of the terminal
equipment. Standard jacks shall also be arranged
that, if the plug connected thereto is withdrawn,
Compliance Information