SoundExpression SE14SRS, Руководство пользователя

Страница: 12 / 72

12
SoundExpression
CAUTION: When connecting cables, be sure
that Pin 1 on the cable, usually marked with
a colored stripe (often red), matches up with
pin 1 on the board connector. A band on the
connector outline denotes Pin 1.
12345678901
12345678901
12345678901
12345678901
12345678901
12345678901
12345678901
12345678901
12345678901
12345678901
12345678901
12345678901
12345678901
1234567890123456
1234567890123456
1234567890123456
1234567890123456
1234567890123456
1234567890123456
1234567890123456
1234567890123456
1234567890123456
1234567890123456
○ ○ ○
○ ○ ○
○
○
○
○
○
○
○
○
○
○
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
ð
CD-ROM audio cable
CD-ROM drive
(rear view)
SPK
L-
O
UT
L-IN
MIC
A white block and “#1” indicate Pin 1
colored stripe
pin
1
12345678901
12345678901
12345678901
12345678901
12345678901
12345678901
12345678901
12345678901
12345678901
12345678901
12345678901
12345678901
12345678901
12345678901
12345678901
12345678901
12345678901
12345678901
12345678901
12345678901
12345678901
12345678901
NOTE: Some CD-ROM drives have jumpers
for a “MASTER/SLAVE” configuration.
Make sure your CD-ROM drive is set for
“MASTER”.
2.4 Connecting to an IDE CD-
ROM Drive
1. Remove the SoundExpression from its
anti-static bag, handling it by its edges
and retaining bracket. Be careful not to
touch the edge connector or any
components on the card.
2. With your computer off, disconnect
any attached devices and power cords.
Remove the system cover and install
the CD-ROM drive (if you are using
one) into your computer. Refer to the
documentation which came with your
CD-ROM drive. Otherwise, skip to 2.5
Inserting the Board.
3. When connecting your CD-ROM drive
(must be IDE type) to the
SoundExpression, connect the ribbon
interface cable from the CD-ROM drive
to the interface connector on the
SoundExpression before inserting the
board into your computer.
4. If an audio cable is included with your
CD-ROM drive, connect it from the
CD-ROM drive to the respective CD-
ROM sound input connector for Sony,
Panasonic, and Mitsumi IDE CD-ROM
drives. Look for the connectors labeled
J11, J10, and J9 in the upper right
corner of the board. See illustration on
next page.