SoundExpression SE14SRS, Руководство пользователя

Страница: 26 / 72

26
SoundExpression
4. Start your communications software
and enter terminal mode. If you are not
in terminal mode, AT commands typed
in at the DOS prompt will result in a
“Bad Command or File Name”
message.
5. Type in ATZ followed by ENTER and
the modem will respond with OK after
a few seconds. If the modem does not
respond OK, refer to Troubleshooting
(Section Four).
6. Type ATH1 followed by ENTER and
you should hear a dial tone from the
external speakers attached to the
SoundExpression. To adjust speaker
volume, refer to your communications
software, or use the ATL3 command.
7. Type ATH followed by ENTER to put
the modem “on-hook”. This confirms
that the modem has been successfully
installed into the computer.
8. Your modem is now ready for use.
Proceed now to your communications
software and documentation.
Ideal for Travelers
Voice features allow for remote call-in
with full services to answer, route, delete,
or forward messages. For example, while
you are traveling, faxes are stored on
your hard drive. When you call in to
review a voice message, a fax forwarding
function allows received faxes to be
forwarded to another fax number at any
location.
3.2 Testing the Connection
1. Check that you have made all
connections as instructed in section 2.6
(Connecting for Modem Use). Power
on the computer.
2. Check for a dial tone on a phone set if
one is connected. If a dial tone is heard,
continue. If you do not hear a dial tone,
check the connections you made in the
previous subsection, or refer to
Troubleshooting (Section Four).
3. Install and configure your
communications software (see
companion software manual) and place
it in command mode. Refer to the
communication software manual for
additional information.