240
HD Camera Unit Parts Identification
b
Remote sensors
These are sensors for the supplied
remote commander.
c
POWER lamp
Lights when the camera is connected to
an AC outlet using the supplied AC
power adaptor and AC power cord.
Flashes in green when the camera
receives an operation command from the
supplied remote commander.
It takes about 7 to 16 seconds to display
the image after the lamp lights.
d
STANDBY lamp
Lights when the camera is turned off
using the remote commander.
Rear
e
Remote sensors
These are sensors for the supplied
remote commander.
f
IMAGE FLIP switch
Flips the image upside down. Normally
set this to OFF when you use the camera.
When the camera is attached to the
ceiling, set this to ON. Before you set the
IMAGE FLIP switch, turn off the
camera (or set to standby mode) and
then, turn the power on by connecting
the power adaptor or by using VISCA
control or the remote commander. When
you switch this, the preset setting is
returned to the initial setting.
g
IR SELECT switch
Select the camera number when you
operate multiple cameras with the same
remote commander.
This is not available on the PCS-XG100/
XG77/XG100S/XG77S.
h
VISCA RS-422 connector
To communicate via RS-422, use this
connector.
Use the supplied VISCA RS-422
connector plug.
This is not available on the PCS-XG100/
XG77/XG100S/XG77S.
i
SYSTEM SELECT switch
Used for selecting the video format of
the signal to be output from the VIDEO
OUT connectors.
For details, see “Setting of the SYSTEM
SELECT switch” (page 241).
j
VIDEO OUT connector
Supplies the image as digital signals. An
analog component signal is also output
from this connector.
k
VISCA IN connector
To communicate via RS-232C, use this
connector. When you connect multiple
cameras, connect it to the VISCA OUT
connector of the previous camera in the
daisy chain connection.
l
VISCA OUT connector
When you connect multiple cameras,
connect it to the VISCA IN connector of
the next camera in the daisy chain
connection.
5
9 0
qa qs qd
6 7 8
Note
Note
