Sony KP-53XBR200 - 53" Projection Tv, Руководство по обслуживанию

Страница: 50 / 144

– 50 –
KP-53XBR200/61XBR200
RM-Y902 RM-Y902
RED
CENT
RED
LIN
Using the green line is recommended for
a crosshatch pattern.
COHP
<COHP ADJUSTMENT>
1. Select “COHP” with the
1
and
4
keys on the remote control.
2. Adjust with the joystick keys on the remote control so that
the slope of upper and lower horizontal lines is minimized
(see below).
<Final Adjustment>
1. Shift to Fine Adjustment mode with the
9
key on the re-
mote control.
2. Use the joystick keys and straighten the vertical and hori-
zontal lines passing through the center spot of the screen. At
this time also adjust the linearity especially in the horizontal
direction of the middle section.
(Effective Adjustment Method)
• This method allows moving to the target position by using
the joystick key on the remote control. Shift as needed by
pressing once at a time on the joystick key and use the
adjust toggle to change the joystick key mode. Check if the
mode has changed by viewing the marker color. (Note that
this cannot be checked with only 1 color on the screen.)
• The marker color changes from white to green (red) each
time the joystick is pressed. Set to white (color) when shift-
ing the marker.
3. Adjust the screen marker from the center to above the vortex
with the
1
key on the remote control. At this point be care-
ful not to change the vertical and horizontal lines that were
aligned in the previous adjustment.
(Use the joystick key mentioned above for the point you want
to align.)
[RED REGISTRATION ADJUSTMENT]
<CENTER ADJUSTMENT>
1. Shift to Rough Adjustment mode with the
9
key on the
remote control.
2. Select “GRN CENT” with the
1
key on the remote control.
3. Switch to RED by specifying that color with the key on the
remote control and align with the joystick to match with the
center point of the screen aligned previously in green.
<SKEW ADJUSTMENT>
1. Select “RED SKEW” with the
1
key on the remote control
while set in Rough Adjustment mode. Adjust the slope of the
vertical and horizontal lines with the
3
and
6
keys.
<LINEARITY ADJUSTMENT>
1. In rough adjustment mode, select “RED SIZE” and “RED
LINE” with the
1
and
4
keys on the remote control and
adjusting while alternately tracking each.
•
H-LIN
Establish points at both ends of the screen as shown below.
Adjust these 2 points and the center point with the
3
and
6
keys so that they match with green point. (In this case,
adjust by using the horizontal line in the center.)
* Usually, the middle section deviates when both ends are
aligned but when the peripheries of both ends are aligned,
an extra margin of movement is obtained making for an
effective adjustment.
•
V-LIN
Select “RED SIZE” and adjust using the joystick keys.
* V-LIN is adjusted only with “SIZE”.