— 20 —
KD-34XBR2
4-2. NORMAL MODE GEOMETRY
ADJUSTMENT
SET-UP CONDITION:
Display Mode: NORMAL (4:3 NTSC)
Picture mode: STANDARD (select the STANDARD mode from the user
menu, then press the RESET button on the remote control to set the
STANDARD settings to the factory settings).
TILT CORRECTION: set to zero (from the user menu).
VERTICAL CORRECTION: set to zero (from the user menu).
NOTE: The NORMAL mode shares the adjustments made in the FULL mode. As a rule
you should not have to make any adjustments in NORMAL mode except the vertical pin
mode which is independent of the FULL mode.
PROCEDURE:
1. Enter the service mode.
2. Display the cross-hatch pattern.
3. Adjust the vertical pincushion.
Device Name
Adj. Item #
Name
Data
2150D-1
6
VPIN
*
* Adjust as necessary to make the horizontal lines as straight as
possible.
4. Write the data to memory.
This completes the NORMAL mode geometry adjustment.
4-3. ZOOM MODE GEOMETRY ADJUSTMENT
SET-UP CONDITION:
Display Mode: ZOOM
Picture mode: STANDARD (select the STANDARD mode from the user
menu, then press the RESET button on the remote control to set the
STANDARD settings to the factory settings).
TILT CORRECTION: set to zero (from the user menu).
VERTICAL CORRECTION: set to zero (from the user menu).
NOTE: The ZOOM mode shares the adjustments made in the FULL mode. As a rule you
should not have to make any adjustments in ZOOM mode except vertical size (ASPT)
and vertical position (SCRL) which are independent of the FULL mode.
PROCEDURE:
1. Enter the service mode.
2. Display the monoscope or cross-hatch pattern.
3. Adjust the pattern so that it is centered on the screen vertically.
Device Name
Adj. Item #
Name
Data
2150D-1
12
SCRL
*
* Adjust as necessary to vertically center the pattern. If the monoscope
pattern is not available, use the cross-hatch pattern’s center dot as the
reference point.
A
B
A = B
Monoscope Pattern
4. Write the data to memory.
5. Display the monoscope or cross-hatch pattern.
6. Adjust the vertical size.
Device Name
Adj. Item #
Name
Data
2150D-1
11
ASPT
*
* Adjust to meet the following spec.:
Monoscope pattern: 9 boxes.
Cross-hatch pattern: 70% of the full pattern height.
Monoscope Pattern
9 boxes
(monoscope
pattern only!)
4. Write the data to memory.
This completes the ZOOM mode geometry adjustment.
Содержание KD-34XBR2 - 34" Hdtv Fd Trinitron Wega
