SolarEdge SE7600A-US, Руководство по установке

Страница: 72 / 116

Power Control Status
This screen is displayed only when Power Control is enabled (available from communication board (CPU)
firmware version 2.7xx/3.7xx and later).
P W R C T R L : R E M O T E
P W R L i m i t : 1 0 . 0 4 k W
C o s P h i : 0 . 9
P o w e r P r o d : 7 0 0 0 W
l
PWR CTRL : The power control status:
o
REMOTE - Communication with the RRCR or smart energy manager is confirmed/validated.
o
LOCAL - The power is controlled locally (e.g. by a fixed limit), or this inverter limits the PV power
production to its relative portion of the feed-in power limit, as a result of disconnected
communication with the smart energy manager. If this status appears, check the communication
to the smart energy manager or the communication to the meter.
l
PWR Limit : The inverter maximum output power set by one of the power limiting options:
o
RRCR
o
Smart energy manager (Feed-in limitation)
o
P(f)
o
P(U)
o
Q(U)
l
Cos Phi : The ratio between active to reactive power
l
Power Prod : The power produced by the inverter
For more information, refer to the Power Control Application Note , available on the
SolarEdge website at http://www.solaredge.us/files/pdfs/application_note_power_
control_configuration.pdf .
Battery Status
This screen is displayed only when the battery is configured, and shows the battery
identification information, its charging status and power, and the operating mode.
B S N : X X X X X X X X X I D : 1 5
S O E : 8 9 % W W W W P W R : 2 W
T o t a l : < x > W h
S t a t e : C h a r g i n g
l
BSN : Battery serial number
l
ID : Battery identification - should be 24 as set up above
l
SOE : State of Energy - the battery capacity percentage (calculated as Available Energy\Max. Energy)
l
PWR : The charging or discharging power (in Watts) according to the battery state (see below)
l
Total : The total discharged energy in Watt/hour
l
State : The battery status: Charging/ Discharging, Idle, Init (pre-heating) or Fault <error code>.
SolarEdge - StorEdge Installation Guide MAN-01-00262-1.3
70
Power Control Status