SolarEdge SE7600A-US, Руководство по установке

Страница: 26 / 116

CAUTION!
HEAVY OBJECT. To avoid muscle strain or back injury, use proper lifting techniques, and if required - a
lifting aid when removing or replacing.
Objet lourd. Pour éviter la fatigue musculaire ou des blessures au dos, utilisez des techniques de levage
appropriées et, si nécessaire - un auxiliaire de levage lors du retrait ou du remplacement.
1. Determine the inverter mounting location, on a wall, stud framing or pole, protected from direct
solar irradiation. To allow proper heat dissipation, maintain the following minimum clearance areas
between the inverter and other objects:
l
If installing a single inverter:
o
8" (20 cm) from the top of the inverter.
o
4" (10 cm) from the bottom of the Connection Unit.
o
4" (10 cm) from the right and left of the inverter.
l
If installing multiple inverters:
o
When installing inverters one above the other, leave at least 8" (20 cm) between the top of an
inverter and the bottom of the Connection Unit.
o
When installing inverters side by side, leave 8" (20 cm) between inverters.
2. Position the mounting bracket against the wall/pole and mark the drilling hole locations :
o
Ensure that the flat edge of the bracket is at the bottom, as in Figure 12 .
o
Use at least two bracket holes. Additional holes can be used to fix the bracket. Determine which
and how many holes to use according to mounting surface type and material.
3. Drill the holes and mount the bracket. Verify that the bracket is firmly attached to the mounting
surface.
NOTE
When mounting an inverter on an uneven surface, you may use spacers/ washers behind the top
mounting hole of the bracket. Depending on the angle, use the appropriate size and number of spacers
so that the bracket is perpendicular to the ground. Recommended: a stainless steel 3/4" long screw,
with a 1/4" socket button head , two jam nuts and three washers.
4. Hang the inverter on the bracket (see Figure 12 ): Lift the inverter from the sides, or hold it at the top
and bottom of the inverter to lift the unit into place. Do not lift holding the Connection Unit as it may
be damaged.
SolarEdge - StorEdge Installation Guide MAN-01-00262-1.3
24
Mounting the Inverter