SMW SPACESAVER 2400S, Инструкция по установке, эксплуатации и обслуживанию

Страница: 61 / 86

Chapter 4 – Operation
SS2400T/S
4-35
10 3 15 0,3
∅
50
Allowance for bar squaring after feeding
4.11.3 PARAMETER SETTING EXAMPLE
Example – Single feeding
Task:
Produce a part long 15 mm from the bar
∅
50 mm. Allowance for bar squaring
after feeding is 0.3 mm, the width of the
cut-off tool is 3 mm. Minimum clamping
length is 30 mm.
Let us suppose that cutting off will take
place 10 mm in front of the clamping
device. As bar ends are wrong (curved),
we will first cut off the new bar face by
1.5 mm.
Barfeeder feeding to the lathe stopper
Parameter
Value Note
#100 48.3 mm 48.3 = 15 + 3 + 0.3 + 30
#101 ??? Depends on the pusher sag.
#300 35 % ---
#010
Stopper
SS2400S
#105 0 mm SS2400S; Parameter is not used.
#106 0 mm SS2400S; Parameter is not used.
#107 0 mm SS2400S; Parameter is not used.
#011 Barfeeder SS2400S
#102 ??? Specific distance to the clamping device face.
#301 1 s Usual value.
#003 Stand Still ---
#004 OFF ---
Barfeeder feeding to position (SS2400S)
Parameter
Value Note
#100 48.3 mm 48.3 = 15 + 3 + 0.3 + 30
#101 ??? Depends on the pusher sag.
#300 35 % ---
#010 Position ---
#105 18.3 mm 18.3 = 15 + 3 + 0.3
#106 0 mm ---
#107 11.5 mm 11.5 = 10 + 1.5
#011 Barfeeder ---
#102 ??? Specific distance to the clamping device face.
#301 1 s Usual value.
#003 Stand Still ---
#004 OFF ---